About Software Updates

LS-Navigator2

Latest update:

07/17/2013

Version:

1.2.0.0

How to confirm the version:

Necessary preparations:

Precautions:

Make sure to confirm the version information for LS-Navigator2 before updating. This update file only functions to update an older version of LS-Navigator2 that has already been installed. Please do not discard the Master Disk that you have purchased, as a new installation cannot be performed using an update file only.

In addition, the Manual folder found in the folder where LS-Navigator2 has been installed will not be updated.

How to update:

1.Download the update file.
This can be downloaded using the following procedures:
- (1)Create a new folder on your hard disk.
- (2)From the selection, follow the instructions given on the screen to download the update file.
  Once a message asking you to run or save this file has been displayed, select save, indicate the folder that was created in step (1) and then click the Save button.
2.Perform the update.
- (1)Unzip the downloaded file named "LS-Navigator2_Update_forLS-9000_ver1_2_0_0.zip".
- (2)After unzipping the file, run "setup.exe" inside the resulting folder.
  Perform installation according to the given instructions.
- (3)Installation is complete once it shows that the InstallShield Wizard is complete.
- (4)Launch LS-Navigator2 and check the first line inside the "Version Information" dialog that is displayed in "Version Information" under the [Help] menu. The update has been properly completed if the version number given below is displayed.
  
  LS-Navigator2 Version 1.2.0.0
  Copyright (C) 2012
  KEYENCE CORPORATION.
  All rights reserved.

Major Changes/Revision History:

[Version 1.2.0.0]: 07/17/2013
- Supports EtherNet/IP® communication unit (CB-EP100) and PROFINET communication unit (CB-PN100) compatible controllers (version 3.01.00)
[Version 1.1.0.0]: 04/15/2013
- Supports BCD unit (CB-BD100) compatible controllers (version 2.00.00)